A - 3
[Installation Precautions]
CAUTION
Use the C Controller module in an environment that meets the general specifications shown in this
manual.
Using this C Controller module in an environment outside the range of the general specifications
could result in an electric shock, fire, erroneous operation, and damage to or deterioration of the
product.
While pressing the installation lever located at the bottom of module, insert the module fixing tab into
the fixing hole in the base unit until it stops. Then, mount the module with the fixing hole as a
supporting point.
Incorrect loading of the module can cause a malfunction, failure or drop.
When using the C Controller module in the environment of frequent vibrations, tighten the module
with screws.
Tighten the screws in the specified torque range.
Undertightening can cause a drop, short circuit or malfunction.
Overtightening can cause a drop, short circuit or malfunction due to damage to the screw or module.
Connect extension cables to the connectors of the base unit and the extension module correctly.
After connection, check them for looseness.
Poor contact could cause an input or output failure.
Be sure to set the CompactFlash
TM
card by pressing it into the CompactFlash
TM
card slot.
Confirm it is completely set.
Poor contact may lead to malfunctions.
Completely turn off the externally supplied power used in the system before mounting or removing
the module.
Not doing so could result in damage to the product.
Do not directly touch the module's conductive parts.
Doing so could cause an operation failure or give damage to the module.
To Next Page
Loading...
