2 - 2
2.1 System Configuration
2.1.1 Devices to be used
2
SYSTEM CONFIGURATION
2.1.1 Devices to be used
(1) When the main base unit (Q3 B) is used
Remark
• Refer to Section 2.1.4 (1) for available base units, extension cables, and power
supply modules.
• Refer to Section 2.2.1 for available I/O modules and intelligent function modules.
Figure 2.1 System configurations when main base unit is used
Main base unit
Commercially available
CompactFlash card
(to be purchased separately)
Battery
C Controller module
Q series power supply/I/O/Intelligent function modules
Extension cable
Extension base unit
To Next Page
Loading...
