Mitsubishi MELSEC Q Series User Manual

APPENDICES
Appendix 6 Parameter No. List
App - 15
17
STARTING MULTIPLE CPU SYSTEM
18
TROUBLESHOOTING
APPENDICES
INDEX
Table App.14 Parameter No. List (Continued)
Parameter No. Item Utility name
C000H Modules CC-Link utility
CNM1H
Remote input (RX)
Remote output (RY)
Remote register (RWr)
Remote register (RWw)
Ver.2 Remote input (RX)
Ver.2 Remote output (RY)
Ver.2 Remote register (RWr)
Ver.2 Remote register (RWw)
Special relay (SB)
Special register (SW)
CNM2H
Start I/O No.
CC-Link utility
Operation setting
All connect count
Retry count
Auto reconnection station count
Wait master station No.
CPU down select
Scan mode setting
Delay information setting
CC-Link utilityBlock guarantee of cyclick data per station
Station information setting
Remote device station initial setting
Interrupt settings
D001H
Start mode setting
Standby watch setting
Debug mode setting
Backup mode setting
D002H Tracking device settings
D003H
Tracking device settings
Signal flow memory tracking setting
Device detail settings
Tracking block No.
Do auto forward Tracking block No.1
(auto ON SM1520)
Device range settings
File register file settings
D004H Group Settings
D5**H
Redundant settings
D9**H
E002H
Refresh settings
E003H C Controller setting utility
E006H Online module change

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English