8 Maintenance
There are no user-serviceable parts inside the DM2020 system. Do not attempt to
disassemble the DM2020 drive or motor, as doing so will void the warranty.
Ø If your DM2020 drive needs to be serviced, return the faulty component(s) to the
factory. See the next section.
WARNING: Electrical hazard - AVERTISSEMENT: risque électrique.
The DM2020 system and connected motor may present an electrical hazard if the
safety precautions are not observed, which may result in death or serious injury to
personnel, or damage to equipment.
Ø Before attempting this operation, follow the safety information and procedures
in General Hazards and Safeguards on page 20.
WARNING: Mechanical hazard - AVERTISSEMENT: risque mécanique.
The DM2020 system and connected motor may present a mechanical hazard if the
safety precautions are not observed, which may result in death or serious injury to
personnel, or damage to equipment.
Ø Before attempting this operation, follow the safety information and procedures
in General Hazards and Safeguards on page 20.
8.1 Periodic Maintenance
Periodically, check the following items:
Component Inspect Frequency
Exterior case Do not immerse or spray the drive with water
or any cleaning agents. Check for accumulated
dust/dirt. If the surface is dirty, clean with a
dry cloth. If the ventilation grids are dirty,
clean with a dry brush.
Application specific (depends on
operating environment, frequency
of use, etc.)
Signal and power
cables
Check for wear, damaged jacket, loose con-
nectors; ensure that all connectors are properly
tightened.
Note that all M-style connectors must be finger
tightened only, do not use tools.
PN: L-MAM2-E-201
Moog Casella DM2020 Installation and Startup Guide
8 Maintenance
To Next Page
Loading...
Need help?
General
