1.4 Required Qualifications of Personnel
WARNING:Personal injury and property damage risk.
Failure to follow all safety precautions when the drive is installed, operated or
maintained may pose a risk of death or serious injury to personnel, or serious
damage to property.
Ø The system builder and end-use company are required to ensure that the safety
instructions detailed in this manual and in the DM2020
Safety
Guide
are
available to, read, understood and observed by all personnel responsible for
the installation, operation and maintenance of the DM2020 system.
In addition to the following information, also follow the instructions in Safety and Usage Guidelines of
this manual.
This manual and the equipment described in it are intended only for qualified personnel who have
proper training and expertise in the following:
l
Transport: All personnel must have knowledge and experience handling components that are
sensitive to mechanical shock and electrostatic discharge (ESD).
l
Unpacking: All personnel must have knowledge and experience handling components that are
sensitive to mechanical shock and electrostatic discharge (ESD).
l
Installation and Maintenance: All personnel must have extensive technical knowledge and
experience with the installation and maintenance of AC- and DC-poweredelectrical and electro-
mechanical equipment.
l
Startup: All personnel must have extensive technical knowledge and experience with electrical
drives, motors and their technology.
The qualified personnel must know and observe the following standards: IEC 60364, IEC 60664, and
all relevant national accident prevention regulations.
1.5 Applicable Laws
The DM2020 drives meet the Low Voltage Directive (2014/35/EU) and EMC Directive (2014/30/EU).
The safety function "Safe Torque Off" (STO) integrated in the drive complies with the Machinery
Directive (2006/42 / EC).
To comply with the European Directives, the drive meets the requirements of the relevant harmonized
installation standards EN 50178 (LVD), EN61800-3 (EMC) and EN 61800-5-2 (Safety of machinery).
The DM2020 drives are CE certified; certain models are also ULcertified. Contact Moog for details.
Standard products has been configured as No Dual Use device.
Output current frequency has been limited to an absolute max parameter >600 Hz to meet
ECCN-3A225 / AL-3A225 requirements.
Other references or information required by the applicable EC directives:
The conformity of products is subjected to observation of the procedures included in the proper
"Installation and Startup Manual".
The user has the primary EMC responsibility in following the recommendations of the manufacturer.
PN: L-MAM2-E-201
Moog Casella DM2020 Installation and Startup Guide
1.4 Required Qualifications of Personnel
To Next Page
Loading...
Need help?
General
