5 Electrical and Mechanical Installation
5.1 Tools and Equipment
This section lists the special tools and equipment needed to install the DM2020 system components.
Note that other tools may be needed, for example, to work in the control panel, terminate cables,
mount safety and/or mechanical components at the machine, etc.
5.1.1 Tools
Have the following tools available for the installation of the DM2020 system:
5.1.2 Electronic Equipment
Have the following electronic equipment available:
l
Digital multimeter (measurement/verification of voltage, amperage, continuity, etc.)
PN: L-MAM2-E-201
Moog Casella DM2020 Installation and Startup Guide
5.1 Tools and Equipment
• Tork T25 screwdriver (fixing connecting BUS BAR)
• M2 la thead screwdriver (insertion connectors)
• M3 lathead screwdriver (for fixing screws and
connectors on the front)
• M4 lathead screwdriver (for fixing power connectors)
• M6 crosshead screwdriver
There is no need for any other specialized electronic equipment.
5.2 Mechanical Installation
This section provides information about the mechanical installation of the DM2020 system.
5.2.1 Assembly of System Components
5.2.1.1. Assembling the power supply
Standard vertical assembly.
Assembly material: 2 M6 cheese-head screws.
In the case of horizontal assembly, please contact the Applications Department to verify the application.
5.2.1.2. Assembling the axes
Standard vertical assembly.
Assembly material: 2 M6 cheese-head screws.
In the case of horizontal assembly, please contact the Applications Department to verify the application.
INFORMATION
When these are to be used, given their considerable weight, install the inductors at the bottom of the cabinet, if
possible near the EMC filter, to reduce emissions in the distribution board
To Next Page
Loading...
Need help?
General
