5.2.1.3 Braking Resistor Positioning
WARNING: Electrical hazard - AVERTISSEMENT: risque électrique
High voltage may be present, which can result in death or serious injury to
personnel, or damage to equipment.
Ø The external resistor must be properly guarded to prevent accidental contact.
Position at the top of the distribution board to facilitate the loss of heat produced. Installation with
brackets supplied for a standard resistor.
Installation on the heat sink (not supplied) for the optional resistor (armoured).
External
Braking
Resistor
(with
brackets)
PN: L-MAM2-E-201
Moog Casella DM2020 Installation and Startup Guide
5.2.1.3 Braking Resistor Positioning
To Next Page
Loading...
