l
Avoid crossing power cables with signal cables
l
Use a shielding cover that is greater than 70%
l
Avoid laying the power and signal cables side by side with each other, especially near the line
filter — always maintain physical separation
l
Avoid the formation of "loops" in the cables, keep the wiring as short as possible and close the
common potential correctly
l
Keep the power cables of the input power separate from those of the motor
l
If the motor is equipped with a brake, keep the 24 V brake cables separated from the signal
(feedback) cables
PN: L-MAM2-E-201
Moog Casella DM2020 Installation and Startup Guide
5.3.2 Electrical Installation
To Next Page
Need help?
General
