Motion Control Engineering 2000 User Manual

Motion 2000 Parameter Settings Record
7-7
7
(OUT40) IO 12 on UIO 36 used for:
(OUT41) IO 13 on UIO 36 used for:
(OUT42) IO 14 on UIO 36 used for:
(OUT43) IO 15 on UIO 36 used for:
(OUT44) IO 16 on UIO 36 used for:
O10 on CPI F used for:
O11 on CPI F used for:
O12 on CPI F used for:
O13 on CPI F used for:
O14 on CPI F used for:
O15 on CPI F used for:
O16 on CPI F used for:
O10 on CPI R used for:
O11 on CPI R used for:
O12 on CPI R used for:
O13 on CPI R used for:
O14 on CPI R used for:
O15 on CPI R used for:
O16 on CPI R used for:
O1 on CPI FX used for:
O2 on CPI FX used for:
O3 on CPI FX used for:
O4 on CPI FX used for:
O5 on CPI FX used for:
O6 on CPI FX used for:
O7 on CPI FX used for:
EXTRA FEATURES
PI Output Type: __ 1 wire per floor __ Binary 1 __ Binary 0
__ Gray code 1 __Gray code 0
__ 1 wire per floor __ Binary 1 __ Binary 0
__ Gray code 1 __Gray code 0
Floor Encoding Inputs? (Hydro only) _____ Yes _____ No _____ Yes _____ No
Encode All Floors? (Hydro only) _____ Yes _____ No _____ Yes _____ No
Intermediate Speed? (Traction only) _____ Yes _____ No _____ Yes _____ No
Emergency Power Operation? __ No Emergency Power Return Floor = ___ __ No Emergency Power Return Floor = __
Light Load Weighing? __ No Light Load Car Call Limit = ____ ___ No Light Load Car Call Limit = ____
Photo Eye Anti-Nuisance? __ No Consec Stops w/o PHE Limit = ___ ___ No Consec Stops w/o PHE Limit = ___
Dedicated Card Reader Security? _____ Yes _____ No _____ Yes _____ No
Card Reader Inputs-Stacked C/H? _____ Yes _____ No _____ Yes _____ No
MG Shutdown Operation (Traction only) _____ MGS Return Landing _____ MGS Return Landing
IND. Cancel Calls on Stop? _____ Yes _____ No _____ Yes _____ No
WPIA Landing? _____ Landing ___ Front ___ Rear ___Both _____ Landing ___ Front ___ Rear ___Both
WPIB Landing? _____ Landing ___ Front ___ Rear ___Both _____ Landing ___ Front ___ Rear ___Both
WPIC Landing? _____ Landing ___ Front ___ Rear ___Both _____ Landing ___ Front ___ Rear ___Both
WPID Landing? _____ Landing ___ Front ___ Rear ___Both _____ Landing ___ Front ___ Rear ___Both
WPIE Landing? _____ Landing ___ Front ___ Rear ___Both _____ Landing ___ Front ___ Rear ___Both
WPIF Landing? _____ Landing ___ Front ___ Rear ___Both _____ Landing ___ Front ___ Rear ___Both
WPIG Landing? _____ Landing ___ Front ___ Rear ___Both _____ Landing ___ Front ___ Rear ___Both
WPIH Landing? _____ Landing ___ Front ___ Rear ___Both _____ Landing ___ Front ___ Rear ___Both
Allow Car Calls on WP Sec? _____ Yes _____ No _____ Yes _____ No
Cancel Both Hall (U/D) Calls? _____ Yes _____ No _____ Yes _____ No
Retain Calls On CTL/CTF? _____ Yes _____ No _____ Yes _____ No
Automatic Floor Stop Option? ___ No Floor # for Car to Stop at:_____ ____No Floor # for Car to Stop at:_____
Car Call Cancel with Direction Reversal? _____ Yes _____ No _____ Yes _____ No
Cancel Car Calls Behind Car? _____ Yes _____ No _____ Yes _____ No
CE Electronics Board? _____ Rev 1 _____ Rev 2 _____ Rev 1 _____ Rev 2
Massachusetts EMS Service? _____No EMS Service Floor #:_____ _____No EMS Service Floor #:_____
BSI Security Key ___ Activated ___ Deactivated ___ Enabled ___ Activated ___ Deactivated ___ Enabled
Program Mode (F1) Parameter Settings Record
OPTIONS CURRENT VALUES
NEW VALUES

Motion Control Engineering 2000 Specifications

General

Brand	Motion Control Engineering
Model	2000
Category	Controller
Language	English