CHANGE/VIEW MTSX RSS
6-4 68P81074C50
6.2.1.1. RADIO WIDE OPTIONS
RSS LOCATION: At the CHANGE/VIEW MENU, press .
MOTOROLA Radio Service Software
MTSX Model:
MAIN:CHANGE/VIEW:CONFIG:RADIO OPTIONS
Use UP/DOWN Arrows to Select Choice.
RADIO WIDE OPTIONS
Alert Tones .......................................Enabled
Min Alert Tone Volume ...........................128
Alert Tone Volume Offset ...................-12.0 Block Pending CA/PC .................Disabled
Self Test Alert Tone......................Disabled Rotary Switch (Scan Prgm)..........Channel
Low Battery Selectable Keypad Mute ..............Enabled
Tx Chirp.........................................Enabled Short Keypress Duration (ms)...............50
Standby Chirp (sec)................................60 Long Keypress Duration (ms)............1000
LED................................................Enabled Maximum Channels (Talkgroups) .......160
Out of Range ............................No Indication Radio Cloning.......Disabled Rollover Alert
Rotary Alert ...............................................
Channel Change ID ..........................Enabled Home Mode Selection..................Enabled
CCID Delay Timer..................................0.0 Secure Equipped.................................Yes
F1
HELP
F2 F3 F4 F5 F6
SECURE
OPTIONS
F7
EMERG
OPTIONS
F8 F9
MORE
OPTIONS
F10
EXIT
This screen allows you to set up various options that affect radio-wide operation. The options on this screen
should be correctly edited and verified before proceeding to edit personality data.
FUNCTION KEY DESCRIPTIONS:
F1 - HELP provides useful information about the currently displayed menu, screen, or field.
F6 - SECURE OPTIONS is used to indicate whether or not the radio is equipped with secure hardware. If your
radio is not Secure equipped , SECURE OPTIONS will not be shown on the screen.
F7 - EMER OPTIONS (Emergency Options) is used to configure radio-wide emergency operation such as Silent
Emergency and Man Down timing.
F9 - MORE OPTIONS is used to configure the Time-Out-Timer table.
F10 - EXIT moves the display backward in the RSS tree, one screen or menu at a time.
PROGRAMMING PROCEDURE:
1. Press F4 at the MAIN MENU. The CHANGE/VIEW MENU appears.
2. Press F3. The RADIO WIDE CONFIGURATION MENU appears.
3. Press F2. The RADIO WIDE OPTIONS screen appears.
4. Press Tab to select the desired field, or press the desired function key (F1 - F10).
5. If a field is selected, press the up/down arrow keys to select choice or value.
To Next Page
Loading...
Need help?
General
