Introductions accomplished, it’s time to get started. In the GETTING STARTED subsection we’ll guide you
through identifying, installing and learning the necessary hardware and software to run the RSS, which will be
used to service and program a radio. In the GETTING STARTED subsection, we’ll also familiarize you with the
computer, the keyboard, and the RSS menus, screens, and fields. The INITIAL SETUP subsection prepares you
for SECTION 2 through SECTION 8, which describe how to service and program a radio, and maintain your radio
service files.
2.1 ASSEMBLING THE HARDWARE
The figure below shows the required and optional equipment to program a radio. The computer recommended is
an IBM
®
Personal System/2
®
model 30 or higher computer, with 640K of RAM, one diskette drive, and one hard
disk drive.
MTSX RSS GETTING STARTED
68P81074C50 2-1
Figure 2-1. Equipment Setup
SECTION 2. GETTING STARTED AND INITIAL SETUP
To Next Page
Loading...
