MTSX RSS GETTING STARTED
68P81074C50 2-33
MOTOROLA Radio Service Software
MTSX Model:
MAIN
Select Function F1 - F10.
MAIN MENU
F1 - HELP
F2 - SERVICE Alignment (Requires RIB)
F3 - GET/SAVE/PROGRAM Codeplug Data from/to Disk/Radio
F4 - CHANGE/CREATE/VIEW Radio Codeplug Data
F5 - PRINT Codeplug Data
F6 - FILE Maintenance
F7 -
F8 - FLASHport Upgrade
F9 - SETUP Computer Configuration
F10 - Exit Radio Service Software, Return to DOS
F1
HELP
F2
SERVICE
MENU
F3
GET
SAVE
F4
CHANGE
VIEW
F5
PRINT
DATA
F6
FILE
MAINT
F7 F8
FLASHPORT
UPGRADE
F9
SETUP
MENU
F10
EXIT
TO DOS
2.12 MAIN MENU
RSS LOCATION: Press any key when instructed on the BANNER Screen.
The MAIN MENU is the top level of the program from which all function selections start. All selections are made
via the function keys, labeled F1 through F10 on the keyboard. All other menus contain an ESC key, and by
pressing it the operator may at any time return to the MAIN MENU. After making a selection, the user will be
directed to similar menus and/or data entry screens for RF alignment or codeplug data. The user must initially
load data from a radio (or disk) via the GET/SAVE function before being permitted to CHANGE/VIEW any
codeplug data. For any problems not covered by the Radio Service Software Users manual or the service
manual, contact the local MOTOROLA field technical representative.
FUNCTION KEY DESCRIPTIONS:
F1 - HELP when pressed provides additional information on this screen. Generic help is available within any
help screen via the MORE HELP function.
F2 - SERVICE is a multi-level menu that permits access to all radio service alignments via the service screens. A
radio must be connected to the computer via the RIB before access will be permitted to the service screens.
All service screens access the codeplug directly, therefore, it is NOT necessary to read the codeplug data
before using the service screens.
F3 - GET/SAVE is used to read codeplug data from a radio and/or retrieve archived codeplug data from a
diskette or hard disk for editing via the CHANGE/VIEW function. GET/SAVE is also used to program edited
codeplug data back into the radio or to create an archive file on a diskette or hard disk.
To Next Page
Loading...
Need help?
General
