3-10 68P81074C50
TUTORIAL MTSX RSS
3.2.11 Fill In the Scan List
Now that the Zone/Channel features are programmed, we'll now fill in the Scan List which was created earlier.
Instruction What to Type How to do it/What it Means
Table 3-9. Steps to Fill In the Scan List
From the Change/View menu, press F3 to see
the Radio Wide Configuration Menu.
Press F5 to see Scan List screen. If "1" is not
already displayed for Scan List number, press
F3 to see previous list. If "1" is displayed,
proceed ahead.
Pressing Tab advances the prompt to the next
field.
Type desired channel number to be scanned.
Press Enter to select desired channel number.
We will assume that factory defaults are
suitable for remaining fields.
Press Esc to exit to MAIN MENU.
1. Go to Radio Wide
Configuration menu
2. Go to Scan List
3. Go to Member Zone
4. Enter "1" (this is the only zone
applicable in this tutorial)
5. Enter channel desired to scan
6. Repeat steps 3 through 5
until all desired channels are
entered.
7. If you have created more than
1 Scan List, repeat entire
table for each scan list
8. Exit to MAIN MENU
To Next Page
Loading...
Need help?
General
