MTSX RSS CHANGE/VIEW
68P81074C50 6-59
Hot DTMF Timing
Timing may be changed for Initial Delay, Digit Duration, and Inter Delay. The radio contains a table with four sets
of values of these parameters. The actual parameters are entered on the Radio Wide Phone Configuration
screen (F4/F3/F4/F9). Factory default is 1.
HearClear
This option allows Hearclear during voice operation. This option is available for 900 MHz systems only.
HearClear is a feature used primarily in the 900 MHz band to reduce noise caused by the smaller bandwidth used
in the 900 band. Factory default is enabled for 900 MHz, otherwise Disabled.
Status Aliasing
This option will permit you to customize the Status number and to assign an alias name to each message (F6).
(For non-keypad models this option can ONLY be used with the One Touch Button Feature (Main Menu-
F4/F4/F3/F9/F5)). The status feature must be enabled on the Trunking Personality screen (F4/F4/F4), and the
status mnemonic (STS) must be assigned on the Radio Wide Menu screen (F4/F3/F3/F4).
Message Aliasing
This option will permit you to customize the Message number and to assign an alias name to each message (F7).
(For non-keypad models this option can ONLY be used with the One Touch Button Feature (Main Menu-
F4/F4/F3/F9/F5)). The status feature must be enabled on the Trunking Personality screen (F4/F4/F4), and the
message mnemonic (MSG) must be assigned on the Radio Wide Menu screen (F4/F3/F3/F4).
Site Aliasing
This option will permit you to customize the site number to assign an alias name to each site. AMSS or
SmartZone Coverage Type, must be added on the Trunking System screen (F4/F4/F3), and the SITE mnemonic
must be assigned on the Radio Wide Menu screen (F4/F3/F3/F4) for this feature to operate properly.
To Next Page
Loading...
Need help?
General
