Journal Printer
How to Replenish the Graphics Journal Printer Paper
NCR Personas M Series 5887 Operator Manual 5-5
12 Pull about 300 mm (12 in.) of paper through the print
mechanism. Fold the end of the paper back on itself to form a
clean, square end.
13 Hold the take-up spindle so that the black end is at the same side
of the printer as the black roll guide.
Insert the folded edge of the paper into the slot on the take-up
spindle and wind the paper around the core two or three times
in the direction shown. Keep the paper central on the spindle.
14 Making sure that the black end of the spindle is against the black
roll guide, push the take-up spindle down between the roll
guides until it clicks into place. Starting with the spindle at an
angle will make it easier to fit between the roll guides.
The paper should wind over the top of the spindle.
1
2
3
To Next Page
Loading...
