NCR RealPOS User Manual

Chapter 5: Programming 5-17
Programming Mode Program Parameters Default Setting
Codabar Decoding Disable
Codabar Length Range Check 4-36
Codabar Specific Length Check 4-36
Codabar Check Digit Disable
Codabar Check Digit Transmission Enable
Codabar Tone Length 75 ms
Codabar Tone Frequency 2232 Hertz
Codabar Tone Disable
Codabar Halves Disable
Codabar Stitch Disable
Codabar Require Start/Stop Match Disable
Codabar Require Quiet Zones Disable
Codabar Start/Stop Transmission Enable
Codabar Hard Correlation Disable
Bar Codes-6
Number of Codabar Scans Required 1 Scan
Pharmacode Decoding Disable
Bar Codes-7
Pharmacode Check Digit Transmission Enable
Identifier Type Default Prefix
Common Byte 1 5 D
Common Byte 2 4 2
Label Identifiers
Note: Default identifiers for each bar code type are available under
Program Parameter Descriptions/Label Identifiers section of this
chapter.
UPC Number System Character Send
UPC–E Number System Character Send
Additional Bar Codes
Options
UPC–A Number System Character Send

NCR RealPOS Specifications

General

Scanning Technology	Laser
Interface	RS-232, USB
Supported Barcodes	UPC/EAN, Code 39, Code 128, Interleaved 2 of 5, Codabar, MSI, Code 93
Storage Temperature	-40° to 70° C (-40° to 158° F)
Humidity	5% to 95% (non-condensing)