: Default
BASIC SERVICE SETTING DATA
301 When system is reseted 0
1
Multiline Terminal MIC lamp ON
Multiline Terminal MIC lamp OFF
311 Display last calling station number 0
1
6 seconds
Until next call
Display calling station number when a calling station abandons
a call before the call is answered
0
1
Not available
Available
313 An Incoming call via UCD station in Exclusive Hold/Remote
Hold
0
1
Not income
To income
319 On a Tie Line outgoing call with answer signal, transferring/
holding the call before distant called station answers.
NOTE: Effective only when CM35 Y=000 is 03 or 04 and
CM35 Y=004 is 02.
0
1
Not available
Available
322 Answering method of Camp-On (Call Waiting Method) 0
1
Same as Camp-On transfer-method
(Switch Hook Flash + Call Hold
access code/Answer key)
Alternating between two calls by
Switch Hook Flash/Answer key
324 Direct-In Termination-Outside
(In the case of no release signal on incoming trunk and both
answer and release signals on outgoing trunk)
[8300R2]
0
1
After the outgoing trunk receives the
response, the tandem connection is
allowed
The tandem connection is restricted
when the incoming trunk is no resto-
ration signal
331 Sender Prepause for outgoing call via attendant 0
1
To provide
Not provided
333 Mail box number sent to VMS when VMS is recalled after
transferring the call to an unanswered station
0
1
To send
Not sent
334 Call to a station with a Return Message Schedule Display, and
receives ringing
0
1
Available (Ringing)
Not available (ROT connection)
335 Station number and name display when incoming call begins
ringing in
0
1
Display when incoming call termi-
nates to the Prime Line
Display when incoming call termi-
nates to the Prime Line or My Line
Continued on next page
To Next Page
Loading...
