: Default
BASIC SERVICE SETTING DATA
352 When a call is transferred by Remote Access to System (DISA)
to predetermined station and time-out occurs, the call is contin-
ued or dropped
See CM30 Y=30 CM41 Y=0>39
0
1
Disconnect call
Continue call
353 Buzzer sound when terminating incoming call to attendant that
is in Attendant Console Lockout
0
1
Not provided
To provide
357 Diversion display on Multiline Terminal/DESKCON when
originating/terminating a call
0
1
Available
Not available
359 When a call is transferred by Automated Attendant to predeter-
mined station and time out occurs, the call is continued or
dropped
See CM30 Y=30, 31, 32, 33 CM41 Y=0>39
0
1
Disconnect call
Continue call
361 Dial “**” is automatically added to the digits sent to Radio
Paging System
0
1
Allowed
Restricted
362 Confirmation tone after dialing access code for Account Code/
Authorization Code/Forced Account Code
0
1
No tone
Service Set Tone
363 For Automated Attendant call, caller dials while receiving
message or music
0
1
Not allowed
(Allowed after receiving the message
or music)
Allowed
365 Send Dial Tone when holding trunk by Hold key
See CM90 Y=00: F0058
0
1
To send
Not sent
367 Camp-On (Call Waiting) Tone sent to busy station by Call Wait-
ing-Station/-Terminating (Camp-On Call Waiting method)
NOTE: In Italy, Belgium, Denmark, Switzerland and Spain, you
have to set setting data to 0.
0
1
Every 4 seconds
Only once
368 Centralized Billing-CCIS for Center Office 0
1
To provide (for Center Office)
Not provided (for Local Office)
369 Automatic return of originating station to the held C.O. line
call, after the inquiry call is disconnected.
0
1
Automatic return to C.O. line call
Return to C.O. line call via hooking,
when receiving ROT
370 Call Forwarding-Outside-CCIS on incoming call from CCIS 0
1
Restricted
Allowed
Continued on next page
To Next Page
Loading...
