: Default
BASIC SERVICE SETTING DATA
371 Call Forwarding Override-CCIS 0
1
Not available (BT connection)
Available
372 Alternative Routing when outgoing trunks of tandem office are
all busy/Alternate Routing for multiple SIP
0
1
Available
Not available
376 When forwarded call is terminated to VMS via CCIS, whether
Message Waiting from VMS is provided for the called station
0
1
To provide
Not provided
377 Send calling party information to SMDR on CCIS tandem calls 0
1
Station number and Office number
Trunk Route number and Trunk num-
ber
378 Centralized Billing-CCIS for Local Office 0
1
To provide (for Local Office)
Not provided (for Center Office)
379 Maximum number of dialed digits sent to the CCIS 0
1
24 digits
15 digits
When a call is terminated via CCIS/SIP, whether Caller ID Dis-
play/Name Display (Attendant Called/Calling Name Display) is
provided for the called station.
0
1
To provide
Not provided
380 Interval of ringer until detecting a ringing frequency from the
main PBX or Centrex.
Ringing is sent from Multiline Terminal until detection of the
ringing frequency.
0
1
As per CM08>381
As per CM35 Y=033
381 Interval of ringer until detecting a ringing frequency from the
main PBX or Centrex.
Ringing is sent from Multiline Terminal until detection of the
ringing frequency.
NOTE: Effective only when the 2nd data of CM08>380: 0.
0
1
No Ringer
Ringing Tone (0.5 seconds) is sent
once
382 Lamp indication of Multiline Terminal until detecting the kind
of incoming call from main PBX or Centrex.
The lamp is lit until detection of the ringing frequency.
0
1
Red steady light
120 IPM flash (As per CM35 Y=032)
386 Destination setting of Call Forwarding-All Calls/Busy Line/No
Answer-Outside or Split Call Forwarding-All Calls/Busy Line/
No Answer-Outside by entering only a trunk access code
0
1
Restricted
Allowed
388 Holding/held party control for Music on Hold tenant basis 0
1
Held party control (tenant)
Holding party control (tenant)
Continued on next page
To Next Page
Loading...
