: Default
BASIC SERVICE SETTING DATA
390 Multiline Terminal tone ringer selection
NOTE 1: Set “0” (Available) by CM08>262 to allow the ring
test tone to be heard when using the “Feature + 3”
operation.
NOTE 2: When the ring tone 600 + 700 (Hz) is specified in
CM15 Y=083, 084 and/or CM35 Y=034, the ring
tone selection key of Multiline Terminal is ineffec-
tive.
0
1
By pressing Feature key and dialing 3
NOTE 1
As per CM15 Y=083, 084, 093,
CM35 Y=034, 164 NOTE 2
391 Lamp indication on Multiline Terminal 0
1
Special
Standard
392 Multiline Terminal ringing signal patterns for external call
[Other than North America]
0
1
2 seconds ON-4 seconds OFF
0.4 seconds ON-0.2 seconds OFF
-0.4 seconds ON-2 seconds OFF
394 Message Waiting lamp indication of Single Line Lamp 0
1
Flashing (1 second ON-1 second
OFF)
Steady lighting
396 Multiline Terminal ringing cadence selection for Internal call
[Other than North America/Australia]
0
1
2 seconds ON-4 seconds OFF
1 second ON-2 seconds OFF
Continued on next page
To Next Page
Loading...
