: Default
BASIC SERVICE SETTING DATA
432 Forced release when called ISDN Telephone does not answer
for 3 minutes
0
1
Not available
Available
434 ISDN CPN (Calling Party Number) when making a call from
ISDN Telephone
0
1
CPN entered in ISDN Telephone
CPN assigned by CM12 Y=12/13
441 Recall display on Attendant Console 0
1
Available
Not available
442 ACD/UCD Busy Out from Sub line 0
1
Available
Not available
443 Type of Voice Mail System (VMS) 0
1
As per CM12 Y=25
VMS with DTMF signaling
444 Message Waiting lamp control from VMS with MCI to all
stations
NOTE: MW lamp control is only available to stations in the op-
posite PBX connected with CCIS via MCI. Station di-
aling MW access codes are not allowed over CCIS.
0
1
Available
Not available
445 Pressing Paging key on DESKCON when the attendant is in
idle
0
1
Available
Not available
448 When Multiline Terminal station dials “*#” during setting of
One-Touch keys
0
1
“*#” is set as dialed digit
“*#” is set as a delimiter mark
between dialed number and DTMF
signal
449 DID call to station with Call Forwarding-No Answer-CCIS set
to a busy destination station.
Destination has no call forwarding set.
0
1
Ring continuously at forwarded DID
station
Drop to busy signal after time set by
CM41 Y=0>01
450 Fault Information Storing 0
1
Not stored
To store
460 Send OAI SMFN STS (status) for Call Transfer from station 0
1
SMFN STS=7
SMFN STS=0
461 Send OAI SMFN when answering held call 0
1
To send
Not sent
462 Send ANI/Caller ID/CPN to OAI terminal 0
1
To send
Not sent
Continued on next page
To Next Page
Loading...
