NEC Univerge SV8300 - Page 196

3-140 NWA-033623-001 Rev.8.1
91ch3002.fm
COMMAND CODE
TITLE:
STATION NUMBER, TRUNK NUMBER, BLADE NUMBER
10
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING DATA MEANING
DATA MEANING
00 TDM terminal/Trunk
registration
See “About Unit
number, Slot number
and Circuit number”
See “Setting
method of Port num-
ber/Station number in
Dual port mode”
XXYYZZ Physical Port num-
ber
XX: Unit number
(01-50)
YY: Slot number
(01-18)
ZZ: Circuit num-
ber (01-32)
D000
D511
Trunk number (C.O./Tie
Line, Paging, Radio Paging)
NOTE 1: This data requires
a system reset for
CCT, and a blade
reset for LDT/
ODT/DTI after
data setting.
NOTE 2: A reset of the
COT blade is
required after
setting of C.O.
trunk (Grand
Start) for North
America.
CM30
CM35
E000
E007
DESKCON number (0-7)
[8300R2]
CM90
CM60
E100
E131
DSS Console number
(00-31)
NOTE: The same number
(the last two digits
of the data) should
not be used, for both
DSS Console
(E100-E131) and
Add-on Module
(EC00-EC31).
CM96
CM97
Continued on next page
~
RESET
BLADE RESET
~
BLADE RESET
~
JUNE/15/2011
CM10