NEC Univerge SV8300 - Page 197

3-141 NWA-033623-001 Rev.8.1
91ch3002.fm
COMMAND CODE
TITLE:
STATION NUMBER, TRUNK NUMBER, BLADE NUMBER
10
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING DATA MEANING
DATA MEANING
00 TDM terminal/Trunk
registration
See “About Unit
number, Slot number
and Circuit number”
See “Setting
method of Port num-
ber/Station number in
Dual port mode”
XXYYZZ Physical Port num-
ber
XX: Unit number
(01-50)
YY: Slot number
(01-18)
ZZ: Circuit num-
ber (01-32)
EC00
EC31
Add-on Module number
NOTE: The same number
(the last two digits
of the data) should
not be used for both
DSS Console
(E100-E131) and
Add-on Module
(EC00-EC31).
CM90
CM98
EE3 XXX Blade number of ZT Inter-
face “XXX” represents ZT
number (000-127)
NOTE 1: “ZZ” (Circuit
number) in the
first data can only
be assigned to
circuit number
01, 05, 09 and 13.
NOTE 2: The same number
(the last three
digits of the data)
should not be
used, for the SIP
Converter num-
ber (EEC000-
EEC127).
CMAD
EFX
EF
XXXX
XXXX
ISDN line station number
X-XXXXXXXX represents
ISDN line station number.
X: 0-9, A (*), B (#)
Continued on next page
~
~
JANUARY/31/2012
CM10