EasyManua.ls Logo

NEC Univerge SV8300 - Page 232

NEC Univerge SV8300
804 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-176 NWA-033623-001 Rev.8.1
91ch3002.fm
COMMAND CODE
TITLE:
STATION CLASS-1
12
: Default
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
90 Registered IP Station MAC
Address display/clear
X.....XXX
(12 digits)
0
CCC
NONE
MAC Address display
MAC Address automatic registration in Fixed Con-
nection Mode
Clear
No data
NOTE 1: If you clear the registered IP Station MAC Address while the system is operating, IP Station is reset
even if it is connected.
NOTE 2: MAC Address automatic registration in Fixed Connection Mode should be executed during the terminal
logging in.
NOTE 3: A maximum of 256 MAC Addresses can be registered in Fixed Connection Mode.
NOTE 4: This command has to be registered after assigning CM15 Y=480 2nd data “1” and CM2B Y=00 in
Fixed Connection Mode. If you do not do that, “DATA ERROR” is displayed.
NOTE 5: Execute the system data backup by CMEC Y=6>0: 0 after this command registered. When changing
this data of terminals accommodated in a Remote Unit, execute the system data copy by CMEC Y=8 to
the Remote Unit.
NOTE 6: Confirm the registered MAC Addresses by CM12 Y=92.
92 MAC Address registration
in Fixed Connection Mode
X.....XXX
(12 digits)
CCC
NONE
MAC Address
Clear
No data
NOTE 1: A maximum of 256 MAC Addresses can be registered in Fixed Connection Mode.
NOTE 2: This command has to be registered after assigning CM15 Y=480 2nd data “1” and CM2B Y=00 in
Fixed Connection Mode. If you do not do that, “DATA ERROR” is displayed.
NOTE 3: When a MAC Address is entered during the terminal logging in incorrectly, “DATA ERROR” is dis-
played. When a MAC Address of the other terminals which is logging in is entered, “WAIT, BUSY
NOW” is displayed.
NOTE 4: Execute the system data backup by CMEC Y=6>0: 0 after this command is registered.
When changing this data of terminals accommodated in a Remote Unit, execute the system data copy
by CMEC Y=8 to the Remote Unit.
93 Protection Mode Cancel
(forced) for DT700 Series
1
CCC
Always displayed when the DT700 Series is pro-
tected
To cancel (forced)
NOTE: When entering “CCC”, regardless of the result, “OK” is displayed immediately.
Continued on next page
JANUARY/31/2012
CM12

Table of Contents

Other manuals for NEC Univerge SV8300

Related product manuals