NEC Univerge SV8300 - Page 347

3-291 NWA-033623-001 Rev.8.1
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
: Default
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
015 Kind of call termination
indicator key/lamp on Atten-
dant Console
Call termination indicator
lamps further categorized by
the kind of calls (e.g.C.O
incoming call or Tie line
incoming call).
[8300R2]
00
07
10
17
20
27
30
37
40
47
75
NONE
C.O. Incoming Call 0 (Standard “LDN” key)
C.O. Incoming Call 7
FX Incoming Call 0 (Standard “FX” key)
[North America Only]
FX Incoming Call 7
WATS Incoming Call 0
(Standard “WATS” key)
[North America Only]
WATS Incoming Call 7
CCSA Incoming Call 0
(Standard “CCSA” key)
[North America Only]
CCSA Incoming Call 7
Tie Line Incoming Call 0
(Standard “TIE” key)
Tie Line Incoming Call 7
Call Termination via No. 7 CCIS
No data
CM90
CM50
NOTE 1: When the standard LED indications are utilized, set the standard data.
NOTE 2: Set the correspondence between the key positions on Attendant Console and this assignment data by
CM90.
016 Sending of Hook Flash to
outside
0
1
Not sending
Sending
CM90 Y=00:
F1009
Continued on next page
~
~
~
~
~
~
~
~
~
~
NOVEMBER/12/2008
CM35