: Default
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
169 Sending Switch Hook Flash
for Adjunct Analog System
0
1
To send
Not sent
170 DID Development Table 0
3
Development Table 1
Development Table 0
CM76 Y=00, 90
NOTE: For SIP trunk, this data is available only for the Development Table 1.
171 Number of digits to be con-
verted on DID for Develop-
ment Table 1
01-08
15
1-8 digits
4 digits
CM35 Y=170
CM76 Y=90
NOTE 1: The number of digits set by this command on DID incoming number is converted by CM76 Y=90. DID
number conversion is started from the last digit of the received number.
(ex.) Received number is 050-1234-5678
- When 2nd data is set to NONE, 5678 is developed by CM76.
- When 2nd data is set to 08, 12345678 is developed.
NOTE 2: This data is effective when CM35 Y=18 and CM35 Y=170 is set to 0.
NOTE 3: When DID number is displayed on LCD of Multiline Terminal or Attendant Console, only the last 4
digits are displayed.
172 Number of digits to be
received for Development
Table 1
01-14
15
1-14 digits
4 digits
CM35 Y=170
CM76 Y=90
173 Call Forwarding-All Calls
on Attendant Overflow
[8300R2]
0
1
Available
Not available
CM08>067
CM35 Y=074
CM41 Y=0>01
CM51 Y=31
174 CID Call Routing for non-
DID on ISDN, Caller ID
0
1
2
3
To provide (Using Development Pattern 0)
To provide (Using Development Pattern 1)
To provide (Using Development Pattern 2)
Not provided
CM2A Y=50-52
186 Alternate Routing for IPT
(P2P CCIS)/SIP
0
1
To provide
Not provided
CM8A
CM35 Y=192
Continued on next page
To Next Page
Loading...
