: Default
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
158 Release of ISDN trunk when
receiving the ISDN DIS-
CONNECT message with
Progress Description=08
from ISDN (effective for an
outgoing call to ISDN)
0
1
To release
Not released
NOTE: When sending the in-band tone to the calling station from ISDN, set the second data to 1.
In this case, the ISDN trunk will be released automatically in 30 seconds after the calling station re-
ceives the in-band tone or when the calling station goes on-hook.
161 DS code point (DiffServ
code point) for SIP trunk
voice packet
00-3F
NONE
DS code point
No data
CM35 Y=134
CM41 Y=2>38
NOTE 1: Set this data when the router provides DiffServ QoS, if required.
DiffServ: Differentiated Services; one type of QoS.
QoS: Quality of Service
NOTE 2: When this data is set, the TOS field Precedence set by CM35 Y=134 is ineffective.
If you want to validate the Precedence set by CM35 Y=134, set “CCC” (data clear) for CM35 Y=161.
NOTE 3: This data setting is required only for Point-to-Multipoint connection.
164 Multiline Terminal Ringer
Tone Pattern on incoming
calls
0
1
See below CM35 Y=034
Multiline Terminal ringer tone pattern is assigned by the following combination of CM35 Y=034 and 164.
Continued on next page
: Default
NOTE: For the Ringer Tone Pattern, see CM65 Y=40.
Y=34 Y=164: 0 Y=164: 1
0 Ringer Tone Pattern 3 Ringer Tone Pattern 0
1 Ringer Tone Pattern 6 Ringer Tone Pattern 1
2 Ringer Tone Pattern 5 Ringer Tone Pattern 2
3 Ringer Tone Pattern 4 Ringer Tone Pattern 7
To Next Page
Loading...
