: Default
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING DATA MEANING DATA MEANING
06 Diffserv Code
Point (DSCP) of
control packet and
voice packet
XX ZZ XX: Location
number
(00-63)
ZZ : Location
number
(00-63)
XX ZZ
NONE
XX: 00-FE: DSCP of
control packet
ZZ : 00-FE: DSCP of
voice packet
C0A0
CM12 Y=39/50
CM8A Y=5000-
5255: 173
CM67 Y=01
NOTE 1: This data is required when the system is connected to the router that provides the Diffserv type QoS
function.
NOTE 2: This data setting is valid to the packets that are sent to the location which is set “ZZ” in the first data
from the location which is set to “XX” in the first data.
NOTE 3: The TOS field precedence that is set by CM67 Y=01 is invalid when this data is set. To be valid the
TOS field precedence, set CM67 Y=01 again after this data setting.
07 Whether the IP
Station at remote
unit location from
IPS through NAT
can communicate
with each other
under the same
NAT or not
XX ZZ XX: Location
number
(00-63)
ZZ : Location
number
(00-63)
0
1
Under the same NAT
Under the different NAT
or Not used NAT
CM67 Y=08
NOTE: The same location number must not be assigned to IP Station that is not accommodated under the same
NAT. However, multiple location numbers can be assigned to IP Station that is accommodated under
the same NAT.
08 Whether the con-
nection between
locations is
restricted or not
XX ZZ XX: Location
number
(00-63)
ZZ : Location
number
(00-63)
0
1
To restrict
Not restrict
CM67 Y=07
NOTE: Restrict the following connection by this command when NAT is used.
-Connection via CCIS (Peer-to-Peer connection)
-Connection between Main Unit and Remote Units
-Connection between locations that are restricted the communications
Continued on next page
To Next Page
Loading...
