: Default
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING
DATA MEANING DATA MEANING
01 Setting of System
Services (b)
10 Control method for Hotel
Feature
0
1
3
PMS, PMS with Hotel/
Motel Front Desk
Instrument, DSS Con-
sole
Hotel/Motel Front Desk
Instrument, DSS Con-
sole, Printer
No data
NOTE: Set this data to “0” for PMS and Hotel/Motel Front Desk Instrument/DSS con-
sole synchronization when using 8300R5 software or later.
11 Partition of Conference
(built-in CPU)
[8300R2]
0
2
3
Four 8-party conference
groups (8+8+8+8)
Two 16-party confer-
ence groups (16+16)
One 32-party conference
group (32)
12 Store of SMDR billing
data
[8300R3]
0
1
3
SRAM (Maximum
27000 calls)
SRAM (Maximum
12000 calls)
SDRAM (1023 calls)
CM08>896
NOTE 1: After change this data, execute the SRAM memory clear by CM00>02 or
CM00>11. When VRS built-in CPU is used and this data is changed 3 to 1,
SRAM memory clear is not required.
NOTE 2: Execute the SRAM area all clear by CM00>02 (SRAM area all clear) before
change this data, when call charge printout is executed.
NOTE 3: When this data is set to default data, all the SMDR billing data is cleared by
System Reset.
NOTE 4: When this data is set to “0” (SRAM [Maximum 27000 calls]), SRAM cannot
be used for Voice Response System (VRS).
14 Select of PMS Interface
[8300R3]
0
3
RS-232C
TCP/IP
Continued on next page
To Next Page
Loading...
