NETGEAR M4100 Series User Manual

Configure System Information
116
M4100 Series Managed Switch
10. Use the Recurrence Pattern to show with what period the event repeats. If recurrence is
not needed (a timer schedule should be triggered just once), then set Date Stop as equal to
Date Start. The following recurrence values are available:
• Daily. The timer schedule works with daily recurrence.
The Every WeekDay selection means that the schedule is triggered every day from
Monday to Friday. The Every Day(s) selection means that the schedule is triggered
every defined number of days. If the number of days is not specified, then the
schedule is triggered every day.
• Weekly. The timer schedule works with weekly recurrence.
- Every Week (s). Define the number of weeks when the schedule is triggered. If
number of weeks is not specified, then the schedule is triggered every week.
- WeekDay. Specify the days of week when the schedule operates.
• Monthly. The timer schedule works with monthly recurrence.
Show the day of the month when the schedule is triggered. The Every Month(s)
selection means that the schedule is triggered every defined number of months.
11. Click the APPLY button.
The updated configuration is sent to the switch and takes effect immediately.

NETGEAR M4100 Series Specifications

General

Model	M4100 Series
Switch Type	Managed
Form Factor	Rack-mountable
Port Configuration	24 or 48 ports
Ethernet Ports	10/100/1000 Mbps
PoE Support	Available on some models (PoE and PoE+)
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
QoS	Yes
Stackable	Yes
Ports	24 or 48
Jumbo Frame Support	Yes
Security Features	ACL, 802.1X, RADIUS, TACACS+
Operating Temperature	0° to 50° C (32° to 122° F)
Storage Temperature	-20° to 70° C (-4° to 158° F)
Power Supply	Internal power supply