Configure Switching Information
184
M4100 Series Managed Switch
2. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3. Launch a web browser
.
4. Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
7. Select Switching > MVR > Advanced > MVR Configuration.
8. Select the MVR Running Disable or Enable radio button.
The factory default is Disable.
9. In the MVR Multicast VLAN field, specify the VLAN on which MVR multicast data is
received.
All source ports belong to this VLAN. The value can be set in a range of 1 to 4094. The
default value is 1.
10. In the MVR Global query response time field, set the maximum time to wait for the IGMP
reports membership on a receiver port.
This time applies only to receiver-port leave processing. When an IGMP query is sent
from a receiver port, the switch waits for the default or configured MVR query time for an
IGMP group membership report before removing the port from the multicast group
membership.
The value is equal to the tenths of second. The range is from 1 to 100
tenths. The factory default is 5 tenths or one-half.
11. Use the MVR Mode field to specify the MVR mode of operation.
The factory default is Compatible.
12. Click the REFRESH button to update the screen to show the latest MVR configuration.
To Next Page
Loading...
Need help?
General
