NETGEAR M4100 Series User Manual

Configure System Information
23
M4100 Series Managed Switch
The Login screen displays.
5. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
7. Select System
 Management System Information.
8. Define the following fields:
• System Name. Enter a name to identify this switch.
You can use up to 255
alphanumeric characters. The factory default is blank.
• System Location. Enter the location of this switch.
You can use up to 255
alphanumeric characters. The factory default is blank.
• System Contact. Enter the contact person for this switch.
You can use up to 25
alphanumeric characters. The factory default is blank.
• Login T
imeout. Specify how many minutes of inactivity can occur on a serial port
connection before the switch closes the connection. Enter a number between 0 and
160: the factory default is 5. Entering 0 disables the time-out.
• Management Interface — Select the management interface to be used as source
interface for SNMP trap, syslog, DNS,
TACACS+, RADIUS, sflow, and SNTP
applications. Possible values are as follows:
• Routing Interface
• Routing VLAN
• Routing Loopback Interface

NETGEAR M4100 Series Specifications

General

Model	M4100 Series
Switch Type	Managed
Form Factor	Rack-mountable
Port Configuration	24 or 48 ports
Ethernet Ports	10/100/1000 Mbps
PoE Support	Available on some models (PoE and PoE+)
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
QoS	Yes
Stackable	Yes
Ports	24 or 48
Jumbo Frame Support	Yes
Security Features	ACL, 802.1X, RADIUS, TACACS+
Operating Temperature	0° to 50° C (32° to 122° F)
Storage Temperature	-20° to 70° C (-4° to 158° F)
Power Supply	Internal power supply