GENESYS User Manual Issue 1
8T AUXES Section
ISO
Isolates the 8T from the Solo system, so that when any other 8T SOLO is
detected on the console, that channels 8T is not cut.
SEL
Puts a pair of strips into SEL Mode enabling you to set Pre/Post states of
the 8T Auxes.
There is a single SEL button for each pair of 8T faders.
> Press SEL, hold and then release.
SEL is interlocked with all other SEL buttons on the Channels and 8T
strips, so that pressing a SEL button will cancel a SEL button that may be
selected elsewhere.
INS
Switches the 8T Insert On/Off.
PRE
Sets whether the 8T Insert is Pre- or Post- the 8T fader.
The led will light when set to PRE, and go off when set to POST.
- 34 -
To Next Page
