GENESYS User Manual Issue 1
Master Screen
As SEL Mode on the monitor panel allows you to make individual changes
mid-way through a session on the console surface, so the SETUP screen
allows you to make the same console-wide changes all in one action.
Any changes made on the console surface in SEL Mode are reflected when
you open the Setup screen, and any changes made on the Setup screen
will be reflected on the console once you Exit.
Common to all the screens, is a large timecode display in the top right.
This can be set to either display:
• Bars & Beats: (Click B&B)
• Foot / Frames (Click F&F)
• Standard Timecode display: (Click DAW TC)
To access all the various options within this application, click the function
buttons at the bottom of the screen.
• If Recall has been fitted, a letter R will be displayed in red in the
top right corner of the main screen just by the timecode display.
• If Recall is not present, the letter R will be displayed in grey
instead.
- 64 -
To Next Page
Loading...
