GENESYS User Manual Issue 1
LS SOLO led
This red led will light to show that the 6 LS buttons are now in destructive
mode and non-latching.
This mode allows for any of the buttons to be lit by selection of any of the
CUT buttons ie if you were to select L CUT, then all the rest would light
(apart from L CUT).
If a Master Cut is selected, it will suspend LS Solos until deselected.
The setting of this mode using Master Cut can be made on the LS Settings
screen, or via SEL Mode on the panel.
L / C / R / LS / S / RS
Will light red when individually selected and cut the appropriate speaker.
All of these buttons will light if Master CUT is selected.
If individual cuts are in place when the Master CUT is selected, these
individual cuts will be reinstated when the Master CUT is turned off.
Also, if some Cuts are selected or not selected when Master Cut is
selected then they will remain cut or not cut even when Master Cut is
deselected, allowing cuts groups to be formed.
Master CUT
Lights red and cuts all of the speakers.
All of the individual speaker buttons will also light red.
DIM
Lights yellow, and dims the speakers by a predetermined amount, set by
the Control Room Monitoring level knob (see below).
The DIM will also be forced onto the monitoring whenever the console
Talkback , production Talkback or Slate are in use or remote dim is
applied.
MONO
Lights yellow and collapses a Stereo or Surround mix into mono.
Collapsing a 5.1 mix is done in conjunction with the ST button.
Main Monitor Pot
In it's default state, this controls the monitoring level to the speakers, the
level being displayed underneath in the alpha display window.
The control ranges from OFF, through -56dB to 0dB.
However, between -14db and -18dB, the display of -15* refers to a fixed
operating level of 85dB.
It is at this level that the control should be set when calibrating external
speakers and amplifiers.
By pressing the knob, it is possible to set up the DIM, AFL, PFL and SIF
levels.
> Press the knob to set the DIM level (the DIM led will light).
The dim level will be shown on the alpha display and has a range of 0dB
to -36dB.
> Rotate the knob to set the value.
Whenever DIM is pressed on the Control Room Monitor panel, it will dim
by this amount.
- 49 -
To Next Page
Loading...
