Neve Genesys - General Fuses - Ratings & Location

102 pages

Save Page as PDF

To Next Page

To Previous Page

GENESYS User Manual Issue 1

General Fuses – Ratings & Location

The AC Distribution block on the left (comprising of 3 x IEC connectors) is not fitted to the 16-channel

add-on modules.

- 97 -

Main Page

Health & Safety Notice2
Console Overview3
Introduction to GENESYS4
Table of Contents5
About this Manual9
- Conventions Used9
- Console Surface Colour Coding9
- Abbreviations & Acronyms10
The Computer Cassette11
- OLD Style (Inc Automation Option)11
- NEW Style12
Optional Console Hardware13
- EQ Cassette13
- Dynamics Cassette13
- Channels AD/DA Cassette14
- Operational Considerations14
- Digital Monitoring Cassette15
Optional Console Software16
- Automation16
- Recall16
Wiring Connections / Setup for HUI Control17
- OLD Type Computer17
- NEW Type Computer18
Powering Procedure18
- Switch on Procedure18
- Power-Down Procedure18
SEL Mode19
- Channel Sel Mode19
- Monitor SEL Mode19
GENESYS Application Scenarios20
- Recording20
- Mixing21
- Live Recording22
- Hui Control of DAW (Inc Sub-Mixing)23
Channel Strip24
CHANNEL Section24
- 48V24
- Hi Z24
- Pad24
- 90Hz Filter24
- Input Trim24
- L/R24
PROCESSING Section25
- Ord25
SEL Mode on the PROCESSING Section25
- To Enter and Exit SEL Mode on the Channel Strip25
- To Allocate Processing Elements Across Channel and Monitor Paths25
- To Set the Order of Processing on the Channel and Monitor Paths25
AUXES Section26
- Master Level26
- >8T Buttons26
SEL Mode on the AUXES Section to Set How the Channel and Monitor Paths Feed the Auxes26
DIRECT OUTPUT Section Master Level27
MONITOR Section28
- L / R Pan28
- Mon Level Control28
- AUT Led28
- Daw28
- I/P 228
- Iso28
- D-MON Led28
- Sel29
- Swp29
- Solo29
- Cut29
- TO MON Leds29
Preventing Feedback Loops30
REVERB RETURNS / AUX MASTERS Section31
REV Return Section31
- To Cue31
- Width31
- Pan / Bal31
- Mono31
- Iso31
- Afl31
SEL Mode on the REV RETURN Section32
- To Set How the Rev Returns Feed the Cues32
AUX MASTERS Section33
- Master Send33
MIX Section33
- Imr33
- Pre33
- Ins33
HEADPHONES Section Master Send33
AUXES Section ISO34
- Sel34
- Ins34
- Pre34
SEL Mode on the 8T AUXES Section35
- To Set Which Auxes Are Fed by the 8Ts35
TONE / RTB Section36
- Sig Pres36
- Rtb36
- Osc Level36
- 2T/MIX36
- Osc Frq37
METERS Section37
- Ch Mtrs37
- 8T Mtrs37
- 2T Mtrs38
MASTER SEL Section39
- Lock39
- MIC39
- Daw39
- DLN Led39
- Swp39
- MIX39
- Ch Safe40
- Mon Safe40
- I/L40
- Latch40
- Reset40
- Link40
- Daw Snd41
- Daw Ret41
- I/P 2 & D-MON Led41
ROUTE SEL Section42
- Filing42
- Load42
- Save42
- Rte Sel42
- L & R42
- Mon43
- Keys43
CUE MIX Section44
- Ext 1-444
- Util44
- Aux 1-644
- Tilt Eq44
- Bal44
- Level44
SEL Mode on the CUE MIX Section45
- To Select the Aux Feeding the Cue45
- To Set the Utility Path Feeding into the Cue45
CONTROL ROOM MONITOR Section46
- Aux 1 - 646
- Cue 1 & Cue 246
- MIX46
- Ext 1 & Ext 246
- Ext 3 & Ext 447
- D-EXT Led47
- Int47
- Ext47
- Sum47
- Ins47
- ST (or Downmix)47
- AFL/PFL Led48
- Pfl48
- Sif48
- M2 Sel48
- Swp48
- A, B, M1 & M248
- S & LS/RS Leds48
- LS solo Led49
- L / C / R / Ls / S / Rs49
- Master CUT49
- DIM49
- Mono49
- Main Monitor Pot49
SEL Mode on the CONTROL ROOM MONITOR Section50
- To Enter and Exit SEL Mode50
- To Tie a Set of Speakers to the Stereo Downmix51
- To Lock Relative Levels Within a Loudspeaker Set51
- To Lock the S and LS/RS to Sets of Loudspeakers51
- To Route 8T Outputs to Specific Loudspeakers52
TALKBACK Section53
- Cue 1 & Cue 253
- Slate53
- Tb All53
- Red Light54
DAW / CONSOLE CONTROL Screen55
- Dyn55
- 2T Operation56
  - 5.1 Mixing Mode56
  - Group Mixing Mode56
- F1 - F557
- Daw57
- Aux57
- Pans57
- Pli58
- Fads58
- Auto58
- Chan58
- Banks58
- Keys58
Faders & Keypad59
Master Faders59
Channel Faders59
- Cut59
- Solo59
- Alpha Display59
8T Faders59
- Cut / solo59
TRANSPORT Keys60
MASTER AUTOMATION Buttons60
Keypad60
MAIN MIX Fader60
Meterbridge61
CHANNEL Meters61
- MIX61
- Mtr61
- 8T 1 to 8T 8 Leds61
- Sig61
REV RETURN Meters61
- MIX L/R61
MASTER METER Section62
- Daw62
- Solo62
- Usb62
- Talkback MIC62
- Ppm62
- Set62
- Peak62
- P/Hold62
- Daw63
- Psu Status63
Master Screen64
Dyn66
- Compressor66
  - Local Mode66
  - Global Mode66
- Gate/Expander67
Trk68
- Group Mode68
- 5.1 Mode68
Daw69
Settings70
- LS Settings70
- 8T solo Linking71
  - Destruct71
  - Safe71
- Power up71
- Software Updates72
- Desk Designer72
- Tie Ch Sel73
- Osc73
  - Osc with Slate73
  - Osc to 2T73
- Setups73
  - Set by Reset73
- Calibrate73
Filing75
- Load75
- FILING Load75
- Save75
- Copy75
- Delete76
Rte76
Encore76
System77
- Reboot77
- Restart PC77
- Shutdown PC77
Audio Monitoring Boards78
- Monitor Board 1 (Cue MIX)78
- Monitor Board 2 (M1 L/S )78
- Monitor Board 3 (MIX Insert)79
- Monitor Board 4 (MIX Output)80
- Monitor Board 5 (Rev Return 4)80
- Monitor Boards 6, 7 & 8 (Rev Returns 3, 2 & 1)80
GENESYS Physical Information81
- Dimensions81
- Connector Types81
Console Connector Pin-Outs82
Computer Cassette82
- Usb82
- Mouse82
- Keyboard82
- Timecode83
- Vga83
Monitor Section Connectors84
- Monitor External Inputs 1 & 384
- Monitor External Inputs 2 & 484
- Loudspeaker Outputs a & M185
- Loudspeaker Outputs B & M285
- Monitor Insert Send86
- Monitor Insert Return86
- Console Outputs - 8Ts87
- Console Outputs - Auxiliaries87
- 8T Insert Send88
- 8T Insert Return88
Channel Section Connectors89
- I/P2 Tape Monitor Send89
- I/P 2 Tape Monitor Return 189
- DAW Send90
- DAW Return90
- Channel Insert 2 Send91
- Channel Insert 2 Return91
- Channel Insert 1 Send92
- Channel Insert 1 Return92
Optional AES Monitoring Cassette, SMN93
- Firewire a93
- Firewire B93
- Socket 193
- Socket 294
- Socket 394
Optional AES Channels Cassette, SMN95
- Socket 195
- Socket 295
- Socket 395
Optional Dynamics Cassette, SMN96
- Key Input96
General Fuses - Ratings & Location97
Appendix A - Processing Cassettes Switch Settings98
- Board ID98
Printing this Manual102

Neve Genesys - General Fuses - Ratings & Location

Table of Contents

Related product manuals