Neve Genesys - Ch Safe; Mon Safe; I;L; Latch

GENESYS User Manual Issue 1
It will also set CH DAW, I/P 2 and DAW RET to be On and will also turn
off CH i/p to direct o/p to stop any DAW feedback.
CH SAFE
Lights yellow and stops the channel SOLO buttons from affecting the Solo
Cuts and 8T Solo Cuts (if linked) when selected.
It also causes the AFL / PFL led to flash and the AFL to switch into the LS
monitor path if a Channel SOLO or 8T Solo is selected.
It will also allow SIF and PFL in the Monitor Section to be selected.
It will also turn SOLO LINK off if selected.
(If CH SAFE is not selected, then the Solo system will be destructive).
In this mode, all channel CUTS will be activated if a channel Solo is
selected apart from the CUT on that particular channel. If a second
channel is Soloed, then the CUT on that channel will be turned off etc.
MON SAFE
Lights yellow and stops the Monitor SOLO buttons from affecting the
Monitor Cuts and 8T Solo/Cuts.
It will enable the AFL / PFL led on the Monitor Panel to flash and the AFL
to be switched into the LS Monitor path if Mon Solo or 8T Solo is
accessed .
It will also allow SIF and PFL in the monitor section to be selected.
Lastly, it will turn SOLO LINK off if selected.
I/L
Makes the Monitor, Channel & 8T SOLO buttons interlock within their
systems.
LATCH
Lights yellow and makes the Monitor, Channel & 8T SOLO buttons latch
within their systems.
NB:
If LATCH is selected while I/L is selected, then I/L will be cancelled.
If LINK is also selected, then LATCH and I/L will operate across Channel
& Monitor Solos, but not 8T SOLO (unless 8T solo has been tied in the
Setup page).
RESET
Cancels any active Solos across the console and returns the audio to it's
Pre- Solo'd state.
This includes any combination of PFL & AFL buttons.
LINK
Lights yellow and makes the Channel and Monitor systems be linked for
Momentary, Interlock and Latch modes in destructive solo, so that any
solo pressed will operate all of the Monitor or Channel Cuts within the two
systems (apart, obviously, for the Cut selected on that Channel or
Monitor).
LINK can only be selected when CH SAFE or MON SAFE are off, and will
be cancelled if either of these two SAFE modes are selected.
- 40 -
Momentary Solo
mode is also
available.
This is selected by
turning both LATCH
and I/L Off.
In this mode, a Solo
will only be heard for
the length of time a
SOLO button is held.