Neve Genesys - Pli; Fads; Auto; Chan

GENESYS User Manual Issue 1
PLI
This button has no function unless you are in DAW mode.
> Press the DAW button.
> Press PLI (the button will light).
Use the  &  buttons to select which HUI paths to control.
The 4 logicators now control the Plug-Ins parameters for the selected
paths:
• F1 opens/closes the PlugIns window in ProTools
• F2 scrolls through the allocated plug-ins for the selected channel.
• F3 / F4 will step you backwards / forwards through the parameters
for the selected channel.
FADS
This button has no function unless you are in DAW mode.
Swaps the faders between controlling the 8T Outputs or the selected DAW
faders.
> Press the DAW button.
> Press FADS (the button will light).
> Use the  &  buttons to move the block of HUI paths up / down a
single path.
> If the BANK button is lit, using the  &  buttons will move the block
of HUI paths up / down by 8 paths.
The block of HUI paths currently under control will be displayed on screen.
AUTO
Automation.
Not available in this release of software.
CHAN
This button has no function unless you are in DAW mode and is only
available if the Automation hardware is fitted.
When selected will switch the console channel faders to control the DAW
and switch off the 8T faders that were controlling the DAW.
BANKS
This button has no function unless you are in DAW mode.
See FADS above.
 &  keys
These buttons have no function unless you are in DAW mode.
They are used to scroll through the available HUI paths & parameters.
- 58 -
The faders
may move to
different levels
when the
FADS button
is pressed and
control is
transferred
between
Genesys and
the DAW.