GENESYS User Manual Issue 1
MON selects the monitor paths within each channel to be trimed.
> Where there are path numbers greater than eight on any type, click the top
button again so the lower row of buttons display 9 – 16, 17 – 24 etc.
8T selects the 8T paths (pre and post) within each 8T module to be
trimed.
> When selecting Pre or Post, click the top button again so the lower row of
buttons display PR 1-8 (Pre) or PO 1-8 (Post).
Mix selects the Left and Right mix o/p's to be trimed.
2T selects the Left and Right 2T o/p's to be trimed.
A/P Selects the AFL and PFL o/p's to monitor to be trimed.
LS selects the Loudspeaker o/p's to be trimed.
REV selects the Reverb return paths within each 8T module to be trimed.
> Click the 1-8 boxes as appropriate and a
will be placed in the selected
box (these buttons are interlocked).
There is now +/- 1dB of calibration available for each path.
> Use the +/- arrows to set a value for each path.
- 74 -
To Next Page
Loading...
