80
After selecting the address of the receiver (from 1 to 8) and the index of your
scanner (from 1 to 4), press “SCAN” so that the MG3000 starts scanning the data
of the respective biometrics.
The loaded parameters will be listed and can be viewed, edited and subse-
quently updated by pressing the “SAVE” key.
Figure 11.10.c
Figure 11.10.b
RS485-2 input or even the internal plug-in LN3000 (module purchased separately
- check availability with technical support).
NOTE: The “Fingerprint quality” parameter refers to the minimum number of valid
points required to perform the validation. The lower the percentage, the fewer
points and the greater the chance of errors in the validation (less secure). The
higher the percentage, the more points and the lower the chance of errors in the
validation (more secure).
The next screen allows the reading and editing of the congurations of each of
the 4 biometrics connected to the RS485 of each of the eight RMF3004 (or 4A
Multifunction Receivers) that can be connected to the MG3000 through the CAN
network.
- ENGLISH -
283
To Next Page
Loading...
