VBA23001-R.3762.A
- A13 ･ D90 -
・Fitting with the bosses.Fitting with the bosses.
・Tighten the two screws (#624) in numeric order ( ①→② ).Tighten the two screws (#624) in numeric order ( ①→② ).→② ).② ).
・Tighten the screw (#698).Tighten the screw (#698).
①
②
・Lower the aperture lever (#208).aperture lever (#208).
・The shutter charge lever (#203) and the aperture driving lever (#207) will form an inverted-V-shaped opening.shutter charge lever (#203) and the aperture driving lever (#207) will form an inverted-V-shaped opening.
・Put the SQ-lever arm section in there as below.
Aperture lever (#208)
Aperture driving lever (#207)
Shutter charge lever (#203)
Screw (#624)
×
2
Screw (#698)
SW-lever arm section
Grease: LEN317A
To Next Page
Loading...
