Nordson EFD E2 - Page 71

E Series Automated Dispensing System
71www.nordsonefd.com info@nordsonefd.com 800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.
Calibrating the Tip Height (continued)
Recalibrate the Tip (Needle Adjust)
PREREQUISITES
 The tip height is calibrated. Refer to “Set a Calibration Point (Initial Setup for Needle Adjust)” on page70.
# Key Press Step Teach Pendant Display
1
> >
• Press F1.
• MOVE UP / DOWN to NEEDLE ADJUST.
• Press ENTER.
[PROGRAM MENU] 1/1
01 Teach/Run
02 Program List
03 Reset Counter
04 Program Offset
05*Needle Adjust
06 Auto Needle Adjust
2
• Press ENTER.
The dispensing tip moves to the user-
dened calibration point.
NOTE: The tip will be 5 mm (0.2") higher
than the calibrated point to prevent
possible crushing of the tip.
Needle Adjust
------------------------------
Press [ENTER] to begin
------------------------------
3
>
• Jog the tip until it is centered over the
calibration point.
• Press ENTER.
The system adjusts the dispense
program to the recalibrated tip height.
Needle Adjust
------------------------------
Jog tip over calibration point
------------------------------
[ENTER]