Nordson EFD E2 - Page 73

E Series Automated Dispensing System
73www.nordsonefd.com info@nordsonefd.com 800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.
Recalibrate the Tip (Auto Needle Adjust)
PREREQUISITES
 The needle detect position is calibrated. Refer to “Set a Calibration Point (Initial Setup for Auto Needle Adjust)” on
page72.
# Key Press Step Teach Pendant Display
1
> >
• Press F1.
• MOVE UP / DOWN to AUTO NEEDLE
ADJUST.
• Press ENTER.
[PROGRAM MENU] 1/1
01 Teach/Run
02 Program List
03 Reset Counter
04 Program Offset
05 Needle Adjust
06*Auto Needle Adjust
2
• Press ENTER.
The system automatically checks the
tip height using the tip detector and
displays the offset updates needed to
calibrate the tip height.
Auto Needle Adjust
------------------------------
Press [ENTER] to begin
------------------------------
3
• After the search is complete, press F1 to
accept the calibration.
Auto Needle Adjust
------------------------------
Searching for tip...
------------------------------
Calibrating the Tip Height (continued)