- 69 -
Table of Setting Items in the Control Panel Menu Screen
Panel Setup
z
Shaded areas are factory-set values.
Item Value Description
Idle Display Supplies Life
Unwinder Config
Sets the information displayed in the standby
screen.
Panel Brightness During Operation 5
～
31
Adjusts the brightness (backlight luminosity) of the
control panel LCD.
The set brightness is applied during control panel
operations.
Panel Brightness While Power Save 0
～
1
～
31
Adjusts the brightness (backlight luminosity) of the
control panel LCD.
The set brightness is applied after the panel
backlight timer time has elapsed from the last
operation.
Panel Backlight Timer 10
～
30
～
300
Adjusts the time (in seconds) from the last
operation until [Panel Brightness While Power Save]
is applied.
Time Setup
z
Shaded areas are factory-set values.
Item Value Description
Date Format yyyy/mm/dd
mm/dd/yyyy
dd/mm/yyyy
Sets the date display mode.
The initial values vary depending on your
operating environment.
Time Zone -12:00
～
+0:00
～
+13:00
Sets the time difference from GMT in 15-minute
units. If the time zone setting is changed, the
time differences before and after the change are
reflected in the current time.
Daylight Saving On
Off
Sets whether to display daylight saving time.
On:
Sets the current time 1 hour forward.
Off:
Sets the current time 1 hour back.
Time Setting 2000/01/01 00 :00
～
2091/12/31 23 :59
Sets the time.
Power Setup
z
Shaded areas are factory-set values.
Item Value Description
Power Save Enable
Disable
Enables/disables power save mode.
Auto Power Off Enable
Auto Config
Disable
Sets auto power off mode.
To Next Page
Loading...
