2-3
2 Quick Start
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual
2-2 MicroHAWK and WebLink
Quick Start
2
2-2-1 Check Hardware and Connect the System
MicroHAWK V420-F
• Mount the reader securely in its stand (not supplied).
• Mount the reader as required by the application.
• Connect the integrated corner-exit cable to the MicroHAWK V420-F.
• Connect the accessory USB cable to the integrated corner-exit cable.
• Connect the USB Type A side of the USB cable to the host.
• Connect the power cable into the power source.
V420-F with DB15 to BUS Power USB Type A
V420-F with DB15 to Ext. Power/USB Type A
Integrated
Corner-Exit
Cable
Accessory USB
Cable to Host
To Host
To Host
Integrated
Corner-Exit
Cable
Accessory USB
Cable to Host
Power Supply
Note: BUS-powered cable delivers reduced illumination –
approximately 30% less brightness.
V420-F with DB15 to Ext. Power/RS-232
Power
Supply
To host
Integrated
Corner-Exit
Cable
V420-F with DB15 to Ext. Power/USB, I/O
To
Trigger
Accessory
USB Cable
to Host
Integrated
Corner-Exit
Cable
To
Power
Supply
To Next Page
Loading...
