2-13
2 Quick Start
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual
2-2 MicroHAWK and WebLink
Quick Start
2
2-2-4 Configure Daisy Chain (If Required by Application)
If errors occur (A group name must be assigned or Group must consist of at least one parent and one
child), resolve them as needed, and then you will see that the Create button will be active. A valid Daisy
Chain configuration should resemble the example below.
If the Daisy Chain was created successfully, the popup will close, and the newly established Daisy
Chain will be displayed as a diagram or map. This diagram is generated based on the number of
devices in the Daisy Chain. Whichever number of devices in the Daisy Chain, the Parent always
appears above and all Children devices below.
To Next Page
Loading...
