Omron NX Series User Manual

Select an extension structure for the data type of variable A.
Variable table
Data type
_sREQUEST_PATH_EX
A
Name
2 Input a value for each extension structure variable member.
Input the following values into the communications parameters that were registered as mem-
bers of the extension structure variable.
Member name of RqPath data type
Variable name
MOVE
EN
IN1_8BIT
3
A . InstanceIDLogicalFormat
A . ClassIDLogicalFormat
A. ClasslD
OUT1
MOVE
EN
I
N1 OUT1
MOVE
EN
IN1 OUT1
256 A . InstancelD
MOVE
EN
IN1 OUT1
TRUE A . isAttributeID
MOVE
EN
IN1 OUT1
A . AttributeIDLogicalFormat
MOVE
EN
I
N1
OUT1
1 A . AttributelD
MOVE
EN
I
N1
OUT1
_16BIT
_8BIT
10-2-6
Service Data and Response Data
CIP communications instructions send and receive data that is stored in array variables.
Preparing Array Variables to Input and Output Service Data and Re-
sponse Data
This section describes the array variables for storing service data and response data that CIP commu-
nications instructions send and receive.
10 CIP Message Communications
10-16
NX-series EtherNet/IP Unit User's Manual (W627)

Omron NX Series Specifications

General

Brand	Omron
Model	NX Series
Category	Controller
Language	English