Omron NX Series User Manual

If the operating mode of one or more CPU Units was changed to download the parameters,
you can return the CPU Units to the previous operating modes. If the No Button is clicked, the
CPU Units remain in PROGRAM mode.
4 The following dialog box is displayed to show that the download was completed.
9-2-10
Uploading Tag Data Link Parameters
You can upload tag data link parameters (such as tag set settings and connection settings) from Ether-
Net/IP devices in the EtherNet/IP network.
The following procedure shows how to upload the parameters. For details on how to connect to the
network from the Network Configurator, refer to 9-2-8 Connecting the Network Configurator to the Net-
work
on page 9-48.
Precautions for Correct Use
• Make sure that the major CIP revision of the device registered with the Network Configurator
is the same as the major CIP revision of the NX-series EtherNet/IP Unit that you use. If the
major CIP revisions are not the same, the parameters may not be uploaded. To determine
whether uploading is possible, refer to 9-2-3 Registering Devices on page 9-17
.
There are two ways to upload the parameters.
Uploading from All Devices in the Network
1 Connect the Network Configurator online, and then select Upload from the Network Menu.
9 Tag Data Link Functions
9-54
NX-series EtherNet/IP Unit User's Manual (W627)

Omron NX Series Specifications

General

Programming Languages	Ladder, Structured Text, Function Block Diagram, Sequential Function Chart
Communication Ports	Ethernet, USB, RS-232C, RS-485
Memory Capacity	Varies by model
Program Memory	Varies by model
Data Memory	Varies by model
Operating Temperature	0°C to 55°C
Power Supply	24 VDC
Ethernet Ports	1 or 2 ports (depending on model)
USB Ports	1 or 2 ports (depending on model)
Dimensions	Varies by model
Weight	Varies by model