Omron NX Series User Manual

Unit Versions
This section describes the notations of unit version and how to check them.
Unit Versions
The unit version is the modification number of the Unit. Even when two Units have the same model
number, they will have some functional differences if they have different unit versions.
Checking Unit Versions on ID Information Indications
The unit version is given on the ID information indications on the side of the product.
The ID information on an NX-series EtherNet/IP Unit is shown in the following figure.
LOT No. DDMYY£
Ver.£.££
££££££££££££
HW Rev.£
PORT1:
££££££££££££
PORT2:
SSSS
ID Information Indication
Unit version
Lot number
Serial number
Hardware revision
MAC address
The meanings of the ID information are shown in the following table.
Name Function
Unit version Shows the unit version of the Unit.
Lot number and serial
number
Shows the lot number and the serial number of the Unit.
DDMYY: Lot number
, £: For use by OMRON, SSSS: Serial number
M is 1 to 9 for January to September, X for October, Y for November, and Z for De-
cember.
Hardware revision Shows the hardware revision of the Unit.
MAC addresses Shows the MAC addresses of the port 1 and port 2 on the Unit.
Checking with the Support Software
Refer to the user’s manual of the connected CPU Unit for how to check the unit version of the X Bus
Unit.
Unit Versions
26
NX-series EtherNet/IP Unit User's Manual (W627)

Omron NX Series Specifications

General

Programming Languages	Ladder, Structured Text, Function Block Diagram, Sequential Function Chart
Communication Ports	Ethernet, USB, RS-232C, RS-485
Memory Capacity	Varies by model
Program Memory	Varies by model
Data Memory	Varies by model
Operating Temperature	0°C to 55°C
Power Supply	24 VDC
Ethernet Ports	1 or 2 ports (depending on model)
USB Ports	1 or 2 ports (depending on model)
Dimensions	Varies by model
Weight	Varies by model