Precautions for Correct Use
The Controller is not restarted. Only the EtherNet/IP port is reset.
• If you click the No Button:
The tag data link settings will not be cleared and the built-in EtherNet/IP port will not be re-
set.
Additional Information
You can also execute the Reset service of the Identity Object for the NX-series EtherNet/IP Unit
to clear the tag data link settings. The procedure to execute the service from the Network Con-
figurator is given below.
1.
Connect the Network Configurator to the network.
2. Select Tool - Setup Parameters in the main window.
Then the dialog box for the general parameter settings are displayed.
3. Specify the target device and message to send.
• Target Node Address
: Enter the IP address of the target device.
• Service
: Select Reset.
• Class
: Enter
01.
• Instance
: Enter 01.
• Attribute
: Enter 00.
• Data
: Enter 02
*1
.
4. Click the Send Button.
9-2-14
Saving the Network Configuration File
You can save device parameters set in the Network Configurator or device parameters uploaded from
the network in a network configuration file.
1 Select File - Save As.
The following dialog box is displayed.
9 Tag Data Link Functions
9-65
NX-series EtherNet/IP Unit User's Manual (W627)
9-2 Setting Tag Data Links
9
9-2-14 Saving the Network Configuration File
To Next Page
Loading...
